My Winter Conundrum

With fall in full swing and winter seemingly around the corner, I’ve been pondering my cycling options.  While it’s true I’ve said I intend to ride all winter long, it should not be construed as “I’m going to ride my daily commute irrespective of the weather”.  Based on 20ish years in Calgary, I expect I’ll be able to get some path/road rides at least every month, if not every week.  I don’t expect to ride outdoors every day by any stretch – I’m not that damaged.

I’ve participated in outdoor activities in the dead of winter.  I’ve put on the long underwear, fleece pants, snow pants, t-shirt, long-sleeve, sweater and finally winter jacket, followed by regular socks, then wool socks and winter boots, a scarf, a balaclava and finally a helmet to go and ride my snowmobile when it’s -30˚C.  You sweat and almost overheat while getting dressed and out to the snowmobile, then the wind sucks away all but the minimum of heat and you’re sledding feeling reasonably comfortable, except that you’re wearing an extra forty pounds of clothing.  This doesn’t sound conducive to cycling.

I’m also not keen on the idea of spending more time pushing than riding.  If I leave early enough to avoid the traffic that will certainly be looking to run me into the snowdrifts, I will get to the paths without trouble.  The path network however is not like our sidewalks – they are not all slated to be cleared.  I can only imagine how much fun it’s going to be to start doing the hike-a-bike in winter gear after a big dump of snow.  So when it’s too bleeding cold or there’s too much snow to ride outside what shall I do?

Ride inside is the obvious answer.  I could ride in the basement once the kids have gone to bed, or before they got up.  Well…not before they got up – that’s not possible – my middle monster doesn’t actually sleep, she only lies in her bed until she’s bored of lying there and then she’s up again.  Looking for company.  I could set up and ride in the garage – private, no little fingers poking into things, no concerns about break downs or flat tires leaving me sweaty and stranded in the middle of nowhere, still winter-cold but no wind so I can dress warm enough to keep from freezing without ending up like A Christmas Story.

So we have the where, now I need the what.  What kind of contraption do I use to ride?  Oh and there are all kinds of options here.  Fluid trainers, mag trainers, wind trainers, inertial trainers, rollers, rollers with resistance, free-motion rollers, trainers that are internet-enabled, trainers that let you rock – or in my case, wobble – back and forth.  The list is almost endless with prices running from under a hundred for the no-name mag trainers to a couple of grand for the internet-enabled, remote controlled, alien-inspired, laser-guided version.  Okay, that last bit isn’t entirely true – you have to use your own laser. Tangent: I don’t have a maintenance stand for the bike so I hang it from the garage roof with a couple of straps.  Once, on a whim and understanding the foolishness of it, I suspended my bike from the garage ceiling such that I could climb aboard and pedal it.  You have not lived until you’ve ridden a suspended bicycle as fast as you can (I was only willing to do it once however as the foolishness exceeded my repeat threshold). /tangent

I’m not in a position to buy the alien technology though I’m sure hooking it into the internet so a virtual Lance Armstrong can lap me before I’ve shifted out of the small ring would do wonders for my ego.  I’m faced with two categories – rollers or trainers?  Rollers will, through negative reinforcement encourage me to use a more disciplined riding style and to pay attention to “my line”.  I like the free-standing aspect – nothing but balance and gyro holding up the bike, lots of focus on cadence and riding smooth. Unless I buy (or build) the free-motion rollers though, I can’t stand and sprint on them.  On the other hand, a fluid or mag trainer can be set up to provide a load for aerobic training or strength training depending on what you’re after, but there’s not the discipline on form enforced as the bike is pinned to the trainer and – at least theoretically – it can’t fall over.

I can throw the bike on the rollers and ride – theoretically – without having to do any more than I would if I was going for a ride on the paths.  The trainers all lock on to the rear axle, an act that would take at least 15, perhaps 30 seconds of my precious ride time.  A trainer is rumoured to be harder on the rear wheel than rollers, but rollers require two smooth (IE not winter knobbies) tires or you’ll be spinning and buzzing the entire time.  In a perfect world I’d have both – the galacticaly-connected super trainer with ego-crushing option and the full-motion rollers with resistance and throw-you-down-and-humiliate options with dedicated bikes for each, in a specially air-conditioned room with large-screen televisions and an endless supply of mental distractions to keep me riding.  This is not a perfect world however.

What say you?  Do you have rollers?  A trainer?  Should I buy the Amazon $60 trainer or will that just be $60 I didn’t put toward the Cycleops trainer or a set of rollers? Have you tried the opposite?  Would you have both if you could?  Have you lost focus at high speed and ridden off the side of your rollers only to have your wheel’s spinning inertia blast you forward into your precariously balanced distraction device, therein wreaking havoc upon your domain?  ’Cause that would be a good story.

2 thoughts on “My Winter Conundrum

  1. I have a Cycleops fluid trainer 2, I love it! I can’t imagine using anything else.

    I get too easily distracted in the house to use rollers and new wife is unhappy enough about the bike being in the house at all, if the bike started leaving skid marks on the floor from where I fell off the rollers, or a nice front wheel shaped hole in the opposite wall then I might lose my indoor biking privileges :>

    It is hard to tell from the amazon.ca el-cheapo pictures how sturdy the stand would be. If it is decently sturdy, then it would be fairly simple to replace the crap-tastic looking resistance unit with a surplus alternator/chain combo leading to some sort of heater/fan/light system to burn off the burn. No wear on the wheels, but a little more of a pain to put the drive chain on and off for off trainer use. But at least it would give you rear granny gear some love, I’m sure it doesn’t get used all that much.

    I took a look at the cycle-ops site. They have their “Wind” trainer listed for around $160 ($134 on amazon.com but no Canada shipping, Bernie? :> ). It seems to get decent reviews with the exception of the noise that it produces and limited top end power. However, in their FAQ section there is a question regarding “can I upgrade by trainer?” and the answer is Yes as long as it was made after 1999. Perhaps the best option would be to buy the Wind with the eventual/next year upgrade to the fluid2.

    or just go for it! Fluid 2, shipped from Canada for $349 including shipping.
    http://www.ebay.ca/itm/CYCLEOPS-FLUID2-BICYCLE-INDOOR-BIKE-TRAINER-/130574746997?pt=LH_DefaultDomain_2&hash=item1e66dc8575

  2. I fear that a “build your own” trainer or roller project would quickly get out of hand and I would have some immobile Rube Goldberg machine taking up half my garage that still wouldn’t do what I need it to.

Comments are closed.